-
Battle Arms Development EKG AK Trigger Kit
Battle Arms Development$52.95MSRP: $57.95The Battle Arms Development EKG Enhanced Kalashnikov trigger group gives an AK a cleaner break and a short, smooth reset, and counts as three US-made compliance parts. Features Hammer geometry... -
Battle Arms Development Rack Ambidextrous Charging Handle AR15
Battle Arms Development$105.15MSRP: $129.95The Battle Arms Development RACK is a monolithic ambidextrous AR-15 charging handle designed for left- or right-side pulls with minimal wear on the upper receiver. Features Ambidextrous: pull from... -
Battle Arms Development Rigidrail M-LOK 13.7" AR-15 Black
Battle Arms Development$199.95RIGIDRAIL™ M-LOK Handguard Features: Proprietary RIGIDRAIL™ rail design to balance between light weight and strength/rigidity Partial Picatinny Top Rail (Matching BAD556-LW Lightweight Upper... -
Battle Arms Development BAD-ASS Ambi Safety Selector AR15/AR10
Battle Arms Development$39.95MSRP: $57.00Battle Arms Deve -
Battle Arms Development Full Auto Bolt Carrier Group AR15/M16
Battle Arms Development$136.95MSRP: $152.95The Battle Arms Development M16-profile bolt carrier group pairs a case-hardened 8620 billet carrier with a shot-peened, black nitride bolt for a durable AR-15 upper. Features M16 full-auto profile...
Description
The Battle Arms Development Enhanced Pin Set replaces mil-spec AR-15 takedown and pivot pins with lower-profile heads that are easier to grip and push out.
Features
- Patent-pending pin heads improve grip and pull strength without oversized heads
- Lower-profile heads than mil-spec; takedown pin head clears a right-side ambidextrous safety lever
- Tips extended 0.030 in over mil-spec for easier push-out from the left side
- Cone-shaped bullet tip guide at both ends helps prevent tool slip and receiver scratches
- EZ Guide Channel eases pivot pin installation and helps keep detents and springs from getting lost
- Designed and made in the USA
Specifications
- Material: Steel pins, hardened stainless steel detents, 17-7 nickel-plated stainless steel springs
Fits
- AR-15, M16 and M4 lower receivers with mil-spec .250 in pivot and takedown pin holes
- AR-9 lowers per BAD
- Not for LR-308 (separate BAD-EPS-308)
In the box
- Enhanced takedown pin (BAD-ETP)
- Enhanced pivot pin (BAD-EPP)
- 2 hardened stainless steel detents
- 2 nickel-plated stainless steel pin springs
